Connecting a station to the platform

For GNLT chargers of the EVB and EVE series. Takes about 5 minutes.

The GNLT app configures the station itself, over Bluetooth. Walk up to it with your phone, fill in four fields — and the station connects to your network and to the platform. After that you control charging, the schedule, the price and the statistics from any distance.

A couple of minutes.

1. Install the GNLT app and sign in

   If you do not have an account, sign up with a phone number or an email address. The station is linked to that account.

2. Turn on Bluetooth on the phone and walk up to the station

   Without Bluetooth the app cannot see the station. While you are at it, allow the app access to your location: then your network name is filled into the form automatically, with no typos, and the station is placed on the map.

   Why this matters. A typo in the network name or the password costs dearly: the station accepts the settings, switches to Wi-Fi, fails to connect — and turns Bluetooth off. After that it can only be fixed by hand on the station itself.
   If the station has been set up before. A new station has Bluetooth on — nothing to do. But if OCPP or Modbus were switched on in its settings, Bluetooth is off. Turn those modes off on the station: Settings → Wi-Fi → OCPP. You do not need to turn Wi-Fi itself off — it does not interfere with Bluetooth. If that does not help, reset the station to factory settings and restart it.

Three steps: one on the phone, two on the station.

1. In the app: “My stations” → “Add a station”

   The app takes you through three short screens: station number and PUK code → “Find the station” via Bluetooth → Wi-Fi network name and password, then “Set up the station”.

   GNLTAdd a station

   Station serial number 302511017394

   The PUK code 30••94

   Wi-Fi network name teploeffect

   Network password ••••••••

   Set up the station

   • The serial number does not have to be typed — there is a button next to it for scanning the QR code on the casing.
   • The PUK code confirms that the station is yours. It is on the back of the manual.
   • The network name is filled in automatically if the phone is connected to the same network.
   • The password can be revealed with the “Show” button and read letter by letter.
   • The app writes in the server address and the station number itself — there is nothing to type.

2. Wait for the Wi-Fi icon on the station display

   It appears in the top row once the station joins your network. This usually takes up to a minute.

   10:37 MON06.07.2026

   0.0 / 32 A

   SN: 302511017394 Total: 4828.61 kWh

   • The Wi-Fi icon is in the top right corner. While it is missing, the station has not joined the network.
   • The icon has not appeared? The network name or the password did not match. Go back in the app and check them.

3. Turn OCPP on at the station

   On its display: Settings → Wi-Fi → OCPP. The switch is hidden inside the Wi-Fi section, below the network name and the address. This is done once.

   Wi-Fi

   Turn on

   Connected

   teploeffect

   IP: 192.168.100.6

   OCPP 1.6-J

   ChargeID: 302511017394 URL: ws://csms.gnlt.by/ocpp/

   • The number and the address have already been written in by the app — there is no need to check or edit them.
   • Do not turn OCPP on before the Wi-Fi icon appears. While the station is not on the network there is nothing to enable, and working out what went wrong becomes harder.
   • After it is enabled the station connects to the platform within a minute.

The app finds the station itself and adds it under “My stations”. From there you get starting and stopping charging, the current limit, the schedule, scenarios, the price and the statistics.

If the station has not come online